文件操作 - CIM_BGPIPRoute.mof
返回文件管理
返回主菜单
删除本文件
文件: /usr/share/mof/cimv2.43.0/Network/CIM_BGPIPRoute.mof
编辑文件内容
// Copyright (c) 2005 DMTF. All rights reserved. // <change cr="ArchCR00066.004" type="add">Add UmlPackagePath // qualifier values to CIM Schema.</change> // ================================================================== // CIM_BGPIPRoute // ================================================================== [Version ( "2.6.0" ), UMLPackagePath ( "CIM::Network::BGP" ), Description ( "BGPIPRoute describes a BGP routing entry that connects two " "peer routers that are running BGP. The source and destination " "addresses may be either specific IP endpoints or IP subnets. " "Examining the BGPIPRoute class definition, note that its " "superclass IPRoute is deprecated. Unfortunately, IPRoute " "cannot be removed from the object hierarchy without a major " "Schema release. When/if this occurs, the IPRoute superclass " "will be removed, and BGPIPRoute will subclass from " "CIM_NextHopRouting directly." )] class CIM_BGPIPRoute : CIM_IPRoute { [Description ( "Usually, the administrative distance is used to " "determine which route gets installed in the routing " "table. Using this scheme, routes learned via EBGP will " "win over routes learned via an IGP. If this is not " "desired, then this assigns the administrative distance " "of this route to be equal to that of a local route, " "which means that the same route learned by an IGP will " "have a lower administrative distance and be installed " "instead." )] boolean IsBackDoorRoute; [Description ( "Loopback interfaces are often used by IBGP peers, " "because they eliminate a dependency that would otherwise " "occur if the actual IP address of a physical interface " "was used to configure BGP. The loopback interface " "instead instructs the router to use any available " "interface." )] boolean UsesLoopbackPeering; };
修改文件时间
将文件时间修改为当前时间的前一年
删除文件